Description:

The Vessel Tool IBTX2590P10K is a 10-pack of T25 Impact Ball Torsion Bits engineered to survive the punishment of high-torque impact drivers. The ball torsion zone absorbs shock before it reaches the tip, dramatically reducing breakage on demanding fastening tasks. At 90 mm with a 1/4-in hex shank, these bits fit standard impact drivers and drills while reaching screws in confined areas.

• Ball torsion zone absorbs impact shock for significantly longer bit life, rated TOUGH 30X compared to standard bits.
• Proprietary VoHA (VESSEL Outstanding High-Performance Alloy) steel achieves 62 HRC hardness for superior wear resistance under repeated impact loading.
• T25 Torx tip engages a wide range of common fasteners used in construction, automotive, and manufacturing applications.
• 3-9/16" (90 mm) overall length reaches screws in tight or recessed locations that shorter bits cannot access.
• 1/4-in hex shank fits all standard impact driver and drill quick-change chucks without adapters.
• Made in Japan to tight manufacturing tolerances for consistent tip fit and reduced cam-out.
• 10-piece bulk pack keeps high-demand work stations stocked and reduces downtime between bit changes.

These T25 Impact Ball Torsion Bits are purpose-built for power tool use in high-cycle environments. The distinctive ball torsion section between the shank and tip acts as a flexible buffer, converting destructive peak torque spikes into controlled torsional flex. This mechanism protects both the bit tip and the fastener head, reducing strip-out on repeated drive-and-remove cycles. The VoHA alloy steel achieves 62 HRC -- among the highest hardness ratings available in impact-rated bits -- giving the tip geometry exceptional edge retention over the life of the bit.

Each bit features a precision-formed T25 Torx profile that engages fasteners cleanly from the start of the drive stroke. The 3-9/16" (90 mm) body length provides the reach needed for deck screws, panel fasteners, and structural hardware that sit below the work surface. The 1/4-in hex shank locks securely into any standard quick-change chuck, eliminating slippage under torque.

This 10-pack is well suited for contractors, assembly technicians, and tradespeople who cycle through T25 bits at a high rate. Bulk packaging keeps stock on hand and makes it easy to replace bits as part of routine maintenance rather than waiting for a tip to fail mid-job.

Includes:

• (10) T25 x 90 mm Impact Ball Torsion Bits